RGB Matrix Panel Drive Board For Raspberry Pi [Version]

Description Please NOTE there is a board design problem from around 2025 Feburary until 2025 April. Please see explanation here.  MPC1119 is the version applied the quick fix on old stock, no problem to use, but has an external wire. MPC1120 is the new fullly fixed board, without any external wires or fix. The new version of RGB matrix panel drive board, the first version please find here. This drive or interface board allow raspberry pi to drive most sizes of RGB matrix panel, software can check hzeller repository, code by C or python. You can build very large indoor or outdoor screen and control by RPI. This new version has following changes MPC1119-V1: Removed the DS1302 RTC and EEPROM functions and circuits, which are not used by most customers. Changed to angled connectors to lower the total height, so it can be fit into some enclosures, as customer requested. This is experimental, the connector also block the installation holes underneath, and outer of the PCB. Added two channels of power supply, one channel of input power supply 5Vwith over-voltage and over-current protection, and same one channel of output power supply 5V. Package included the 8.5mm connectors, but not soldered for the height reason. Features: Reserved 2*3 pin holes: 5V/GND/3V3 Reserved 1*2 pin holes: ROW_E to GND pin holes, default pull up. Reserved free GPIOs: ID_SD ID_SC pins Reserved 2*4 pin holes: E_BUFF / P4 / P8 / GND pins. Reserved GPIOs: Reserved GPIOs pins for the chain 3 last chip. You can use the pins directly on the chain 3 hub75 output at logic 5V You can also remove the last chain 3 74HC245 logic convert chip, and use pins directly from raspberry pi 3.3V logic Any other suggestions please email us, we can continuously improve this. Documentation, demos, more silimilar products please see on this page.